Steps to Reinitialize Printer After Fuser Roller Swap > 자유게시판

• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

After replacing the pressure roller in your printer, it is critical to refresh the printer’s firmware parameters to prevent operational errors. The pressure roller coordinates with the fuser unit to apply heat and pressure to bond toner, and when it is replaced, the printer may not detect the new component unless its firmware memory are reconfigured.

Begin by powering down the unit and disconnecting the power cord. Wait for at least one minute to eliminate stored electrical charge. Then, plug it back in and turn it on.

Once the printer has completed its startup sequence, open the printer’s interface. Look for a menu option labeled service, configuration, or tools. Navigate to the factory restore or calibration section. Some printers offer a dedicated setting for reset fuser. Choose this setting and press OK to proceed.

If your printer does not have a direct option, refer to the manufacturer’s guide for a secret reset procedure, which may involve holding a button during power-up.

After completing the reset, generate a nozzle check to ensure print quality has been restored. If you still encounter issues such as paper jams or smudged text, verify that the pressure roller was installed correctly and غلطک پرس پرینتر that wiring is intact.

If problems continue, reach out to customer service for model-specific guidance.

Resetting the settings after a roller replacement ensures that your printer operates as intended and enhances long-term reliability.